Clone MB-PRO II Programming Mercedes Key

This is a Mercedes key programming display by clone MB-PRO II auto key programmer.

Tools to use:
Mercedes key programmer;
Keys (original and blank);
Laptop;

Steps:
1. Check original key’s ver soft & download data from car
2. Get PSW from key
3. Decoding
4. Program a new key

1. Check original key’s ver soft & download data from car
Insert the original key on MB key programmer and read data.
MB-PRO Il key programming -1
Double click “mercedes key tool_beta”.
MB-PRO Il key programming -2
Choose “Key Module”.
MB-PRO Il key programming -3
Click “IR Prepared Key” and then click”READ”.
If the Ver Soft is 57, then the new key will be programmed.
MB-PRO Il key programming -4
Get the car ans download data.
Click “EZS Module”.
MB-PRO Il key programming -5
EZS Type: MOTO (before 2008)
EZS Type: NEC (after 2008)
Click “Read Data”.
Insert the reader in the ignition to get data.
MB-PRO Il key programming -6
Read EZS data Finish. Click “Save Data”.

2. Get PSW from key
Take off PCB board from the original key.
Desolder the chip.
MB-PRO Il key programming -7
Put the chip on the MB Pro II reader.
MB-PRO Il key programming -8
Choose “New Adapter”.
Click “57 Tool”.
Click “Read PSW”.
Click “Yes”.`
Here is the password.
MB-PRO Il key programming -9
Click “Save PWS” to save data.
Save Finish and close “Key Module”.
Click “EZS Module”.
Click “Load DATA” to download file that was saved before.
Click “Load PSW” to save PSW data.
Save data again.

3. Decoding
Click “SKC” to decode data.
Click “I accept”.
Click “Load Dump”.
Select file that was saved before.
Click “CALC KEYS” to decode key’s data.
MB-PRO Il key programming -10
Calculating code….(it will take 10 minutes).

4. Program a new key
Click “mercedes key too_beta”.
Select “Key Module”.
Insert a new key on MB Pro II Auto Key Programmer.
MB-PRO Il key programming -11
Click “IR Prepared Key”, and then click “READ”.
Click “LOAD FILE”.
Select the key number which you want to add and program.
Click program.
Programming a new key….
Complete.
Check the new key’s data.
Insert the new key in the ignition.(key’s LED light on)
Then plug it out.
Again, ithe new key in the ignition.(light on)
Then plug it out.
For the third time, insert the new key.(key’s LED light off)
Then start the car, to check the key works or not.
If the new key is working, back to step 3. Decoding and rewrite key data to original.
EX: If your original key is No.2, you should select No.2 and decode key data to rewrite.

Done.

Read more:
http://www.worldobd2.com/wholesale/advanced-key-programmer-for-mercedes-benz.html

Copy Protected by Chetan's WP-Copyprotect.