How to Reset KESS V2 Firmware V4.036 Tokens?

Recently some customers feedback that how to reset KESS V2 Firmware V4.036 Tokens when tokens run over, here wobd2 engineer will guide you how to reset tokens step by step.

First of all, connect device with laptop (see below picture), don’t connect with car.



Before running the application, you should disable both local area connection and wireless network connection, otherwise you may get the interface damaged.



Then check if Ksuite is well installed or not

Open My Computer->Device Manager->Universal Serial Bus Controller-> USB Device



Extract [Tool] file to desktop and copy the three files inside to the desktop.



Cut [] file to Disk C: //, unzip the file

Rename [Token1.tok] on the desktop as [Token47.tok]



Format the 2GB TF card



Unzip [] file to the new 2G TF card



Rename [Token47.tok] on the desktop as [Token48.tok] and copy the [Token48.tok] to [Tokens] folder



Delete [KSuite-tokens] folder on Disk C:// and extract the [] file again and open it

Rename [K10033818.CFG] as [139K10033818.CFG]



Cut [139K10033818.CFG] file to [Update] folder (“KSuite” -> “Update”)



Open [K10033818]

Click “OK” to continue

Browse the folder to C:\\KSuite tokens\KSuite

Then click [Reset Token Count]



Done! You can open KESS V2 FW V4.036 now.



If you think this process is too much cumbersome, I suggest you choose another product KESS V2 Manager Tuning Kit, It is also a powerful product.

Once your tokens run over, just click this button (pictures shown below), then tokens will go back to 30 tokens. You can go on to use it again. No need change new tokens chip, no need desolder and program the tokens chip. More easily than ever!



That’s all!

More Product information Please Search: WOBD2 (World OBD2 Auto Diagnostic Tool)


Copy Protected by Chetan's WP-Copyprotect.