Reprogram ECU with Autel MaxiFlashPro J2534 and MaxiSys MS908

Last week, I got Autel MaxiFlashPro J2534 and MaxiSys MS908 shipped from China. A little expensive, and it will be better if it can be sold as a combination 😀 But, worth every penny.
My package:
MaxiSys MS908-package
Autel MaxiFlash Pro J2534
Here is the step-by-step instruction about ECU reprogramming with Autel MaxiFlashPro J2534 and MaxiSys MS908 for sharing.

Select “MaxiSys”.
MaxiSys MS908 reprogramming ECM module-1
Select “Diagnostics”.
Tap the second button on the top and select “Auto detect”.
Establishing vehicle communications…
Tap “Yes” for the correct auto scan report.
MaxiSys MS908 reprogramming ECM module-2
Select “Programming/Customization”.
Select “Programming”.
Do the following instruction according to the
“Connect MaxiFlashPro to the vehicle and MaxiSys.
Turn the ignition off.
Verify the vehicle battery fully charged.
Turn the ignition on and the engine off.
Connect MaxiFlashPro to Data Link Connector.
Connect MaxiFlashPro to MaxiSys.
Switch MaxiFlashPro device on and wait for the device to get ready.
After Programming, technician will be given the opportunity to clear diagnostic trouble codes from all ECUs on the vehicle.
The technician may want to record DTCs and Freeze Frame Data befor continuing.
Note:
Please use the USB cable to connect MaxiFlashPro to MaxiSys.
Make sure MaxiSys is connected to the internet before connection”
Select “Yes”.
MaxiSys MS908 reprogramming ECM module-3
Tab OK for the correct VIN.
Select “Reprogram ECU”.
Establishing vehicle communication…
Select “ECU-Engine Control Module”.
Tap “Help” and then tap “OK” to back.
Page down, and select “OK”.
MaxiSys MS908 reprogramming ECM module-4
Select “Engine operation” to go on.
Select this.
MaxiSys MS908 reprogramming ECM module-5
Tap OK.
Tap OK.
MaxiSys MS908 reprogramming ECM module-6
Page down to read ECM information and tap OK to download files.
MaxiSys MS908 reprogramming ECM module-7
Reprogramming…
Programming complete, and read the post programming instructions and tap OK to go on.
( post programming instructions:
If there are no Controller Specific Instructions, turn the ignition off for 30 second to reset the controller.
Clearing DTCs will erase stored history data from alll controllers on the Data Link.
Controller currently in use, Move your interface to any additional auxiliary Data connectors on the vehicle to clear DTCs from other controllers. When finished, return the interface to the Data Link Connector.)
MaxiSys MS908 reprogramming ECM module-8
Tap “Yes” to clear the DTCs.
Establishing vehicle communication…
Tap OK for erase codes command sent.
Tap “NO” for not to proceed the same VIN.
Tap ESC.

END.

Copy Protected by Chetan's WP-Copyprotect.