(solved) BMW E60 keys do not update mileage

Situation:
I have just changed dash on my mates BMW E60 2005. All went well after some minor problems, but it does not seem that the keys picks up the new mileage. I read the keys with AK90 key programmer. At first, the keys mileage lowered each time I checked them with the AK90, closer to the mileage on the dash. OK I thought, maybe this is normal, and will eventually sync with the dash mileage. Then it stopped going the right way, and actually increased every time i checked it instead!

I was told that i have to CAS and drive at least 60 to 100 km for key to sync with CAS mileage, but i have driven maybe 70-80 km and even more than 150 km…still not synced milage with CAS!

Tips:
procedure to manually update the remote control for my 2005 E60:

Sit in the vehicle, close the driver’s door, fasten the safety belt and do not press the brake pedal.

Insert the remote key into the key holder.

Press and hold the central lock button in the unlock position, and then press the start/stop button (to activate KL-15) while continuing to hold the unlock button.

Continue holding the unlock button for approximately 10 seconds after pressing the start/stop button. The gong will sound to indicate that the transfer process is complete.

Remove the key from the ignition.

Repeat the procedure for any additional remote keys.

Note 1: The brake pedal must not be pressed while performing this procedure or the vehicle will start and this Manual Remote Control Update procedure will be canceled.

Note 2: this instruction above is also for BMW E61, E63, E64 (from 9/05), E90, E91, E92, E93, E70, E71, E72, E82, and E88
Note 3: procedure to manually update the remote control for E60, E61, E63, and E64 (pre-9/05 vehicles):

Sit in the vehicle, close the driver’s door, fasten the safety belt and do not press the brake pedal.

Insert the remote key and turn the ignition to position 1 (KL-R).

Press and hold the central lock button located between the center vents.

Switch the ignition to position 2 (KL-15) while continuing to hold the central lock button.

Continue holding the unlock button for approximately 10 seconds after pressing the start/stop button. The gong will sound to indicate that the transfer process is complete.

Remove the key from the ignition.

Repeat the procedure for any additional remote keys.
Note: The brake pedal must not be pressed while performing this procedure or the vehicle will start and this Manual Remote Control Update procedure will be cancelled.

Copy Protected by Chetan's WP-Copyprotect.