The steps Setup V4.94 Digiprog3 Mileage Correction Tool

V4.94 digiprog 3 odometer programmer is the newest version of Digiprog3, which adds more car models on the basic of V4.888. Digiprog III is a cost-effective mileage correction tool supporting multi-language and full range of vehicle. Here is the instruction of Digiprog 3 odometer mater setup.

1. Connect the Digiprog 3 main unit to the OBD diagnostic socket, but do not use the cigar lighter lead. Otherwise, it will lose the warranty.
2. After well connection with vehicle, the Digirog 3 main unit will power on, and the device is loading the system.
3 Then the device screen will display Digiprog III software (free download) version information. Software is marked as unique 12 digit electronic serial number.
4. When your Digiprog 3 has finished loading an information screen will appear with a disclaimer regarding the use of the machine.
5. Click “Check/Tick” button to start using Digiprog 3 odometer correction tool.
--1

6. The digiprog 3 will require password to enter the system. The default password is “1”.
--2

7. Welcome the main interface. You are also allowed to check the software marked red on the picture below.
--3

8. Select the function you need to do and follow the screen instruction.

Note:
The V4.94 digiprog 3 comes with ST01 or ST04 cable, so you do not have to buy extra cable if your ST01/ ST04 cable is available..
ST01,ST04 for Digiprog3

Digiprox 3 adapter list:
http://www.worldobd2.com/upload/pro/4147-digiprog3-adapter-list.pdf

Digiprog III Odometer Programmer Software  Free Download:
http://down.worldobd2.com/digiprog3-manual.part1.zip
http://down.worldobd2.com/digiprog3-manual.part2.zip

A regulated 12V power supply should be used to power your digiprog III. If power up by above 13.5V is used to power the machine, damage may be caused to the main circuit board and it will need to be sent to your Digiprog III dealer for repair.

Copy Protected by Chetan's WP-Copyprotect.