What to do if ICOM A2 prompt “The connection to ISIS is lost”

When I was doing programming with ICOM A2, i cut off the power by accident and then it prompts that “The connection to ISIS is lost..”

icom-a2- ISIS-connection-lost-solved
Possible reasons given:
– ISIS is restarting right now
– ISIS is down
– Networkconfig of the ISIS has changed

Advice given by the system:
– Wait until ISIS is available
– Solve problem of the ISIS (maybe call support)
– Change offline mode

Solution by professional technician at www.worldobd2.com
Click OK.
icom-a2- ISIS-connection-lost-solved (1)

Click here (marked with red).
icom-a2- ISIS-connection-lost-solved (2)

Select “Direct cable”.
icom-a2- ISIS-connection-lost-solved (3)

Switch connection mode to XOVER in progress…
icom-a2- ISIS-connection-lost-solved (4)

Click OK.
icom-a2- ISIS-connection-lost-solved (5)

Click OK.
icom-a2- ISIS-connection-lost-solved (6)

Click here (marked with red)
icom-a2- ISIS-connection-lost-solved (7)

Device is configuring. Do not change anything on network. Network changes may cause an inconsistant system and requires a reboot.
icom-a2- ISIS-connection-lost-solved (8)

If you see the interface below, it means that you succeed in settling “connection to ISIS is lost”
icom-a2- ISIS-connection-lost-solved (9)

Done.
Note:
Tips above are mainly available for China BMW diagnostic mux ICOM A2+B+C.

http://www.bmwicom.org/

Copy Protected by Chetan's WP-Copyprotect.